Galaxy-audio HOT SPOT Handle Installation User Manual download pdf

HANDLE INSTALLATION INSTRUCTIONS

FOR HOT SPOT OR HOT SPOT VC'S WITH FOAM OR CLOTH GRILLES

DISASSEMBLY OF UNIT:

1. Remove the 6 screws found in the perimeter of the bezel.

2. On new style HOT SPOTS, (2004 on), the bezel may be easily removed from the shell. On older

HOT SPOTS the bezel fits tightly inside the perimeter of the shell. For these, use the following

procedure for disassemble.

(a) On a carpet/cardboard-covered bench, set the unit on either of the two small ends with the

front facing you.

(b) With both hands hold the unit by the shell, tip the other end towards you, pick up the about

8-inches, and give it a hard "rap" down onto the bench.

force.

(d) Slide the fast-on spade terminal lugs of the red and black backjack wires from the speaker

terminals, and set the speaker/bezel assembly aside.

SHELL PREP:

1. See attached page 2, and follow steps 1 thru 4.

REASSEMBLY:

1. Reconnect the backjack wires to the speaker terminals.

2. Slide one side of the bezel into the shell. Apply slight pressure to the opposite side of the

bezel and gently "rap" the unit on a carpet/cardboard bench until the bezel snaps into place.

3. Re-insert the 6 bezel screws and tighten.

1 2

Page 1

HANDLE INSTALLATION INSTRUCTIONSFOR HOT SPOT OR HOT SPOT VC'S WITH FOAM OR CLOTH GRILLESDISASSEMBLY OF UNIT:1. Remove the 6 screws found in the p

Page 2

Tool list: #2 Phillips screwdriverDrill9/64" drill bitAwl or similar sharp tool for marking hole placementTape measure or ruler6/32" nut dri

No comments

Galaxy-audio HOT SPOT Handle Installation User Manual