Galaxy-audio CRICKET POLARITY TEST SET User Manual

GALAXY AUDIOMAKERS OF THE ORIGINAL HOT SP T PERSONAL MONITOROPOLARITY TEST SET OWNERSMANUALCRICKET®

8 3. Set receive unit to "MIC", and the "CON/POL" switch to "POL". 4. H

9 and turn up the receiver's gain until only one LED lights. For rooms with high ceilings,

10 B. Balanced cable fault indications. 1. An intact properly polarized device will light the green LED in the 2-T posi

CRICKET POLARITY TEST SET SPECIFICATIONSCRICKET-S Pulse Generator:PULSE WAVEFORM Polarity: positive-goingBALANCED LINE OUTPUT PULSE: Switch selec

GALAXY AUDIOMAKERS OF THE ORIGINAL HOT SP T PERSONAL MONITOROGALAXY AUDIO601 E. PawneeWichita, KS 67211(316) 263-2852(800) 369-7768Fax: (316) 263-0642

Table of Contents How the Cricket works...1 Battery Installation...3 How to Set Units for Testing...

I. How the Cricket works A. Send unit: 1. OFF-ON: This switch turns the unit on and off. 2. LO-HI-SPKR: a. LO: Produces

2: MIC, 2-T, 3-R: a: MIC: Connects the LED metering circuit to the microphone located in the back of

II. Battery Installation for both Send and Receive units (Use only alkaline batteries) 1. Remove the single phillips head screw from the

4 the test and the polarity being checked is that of a speaker connected to the amplifier output.

B. Cables: 1. Balanced: Connect cable between send and receive units using the balanced jacks. Put the

6 5. Test the 3-R position; a non-inverted signal from a balanced output will light the red LED.

7 signal will light the green LED. 4. Test the 3-R position; a non-inverted signal from a balance